0
On a 1999 Oldsmobile 88, the crankshaft position sensor is typically located near the lower front part of the engine, often on the engine block near the crankshaft pulley. To access it, you may need to remove any obstructions, such as the engine cover or other components. The sensor is usually mounted with a couple of bolts and connected by an electrical connector. Always refer to the vehicle's service manual for specific details and procedures.
What else can I help you with?
1998 Oldsmobile 88. has no spark replace the igniton control module. what else could it be?
crank or cam sensor...did you already figure it out?
How do you install a crank sensor to harmonic balancer on a eighty-eight delta royale 88 Oldsmobile?
To install the crank sensor on the harmonic balancer of an '88 Oldsmobile Delta 88, first ensure the engine is cool and disconnect the battery. Remove the harmonic balancer by loosening the bolt and using a puller if necessary. Position the new crank sensor in its designated mounting location, aligning it properly with the harmonic balancer’s signal wheel. Finally, secure the sensor, reconnect the battery, and test the installation for proper function.
Where do you replace the Crank Position Sensor in a 1993 Oldsmobile 88 Royale?
on the front of the motor under the front crank it has a plug going to the crank.
Where is the fuel pump on 1999 Oldsmobile 88?
in the tank
Location of oxygen sensor on a 1996 Oldsmobile 88?
They are in the exhaust flow
Where is the crank angle sensor located on the 88 GL hatchback?
It is integrated in the distributor.
How do you disable brake chime on Oldsmobile 88?
1997olds 88 the brake chime will not shut off where is the sensor so i can disengage it
How do you change a crank shaft sensor for a 93 Oldsmobile delta 88 royale?
on a 90 olds 88 royale your sensor sits inside the timing cover...will need to remove the harmonic balancer (need pulley for that) and remove two screws to take sensor out. replace all parts same way they came out and in same order. passenger side of engine in timing cover
What is the standard tire size for a 1999 Oldsmobile 88?
205/70/15
Where is the cam shaft sensor on a 1989 Oldsmobile 88?
in the intake where the dist. should be on the front of the engine
Where is the cam sensor on a 1991 Oldsmobile 88 located?
the camshsft sensor is located under the water pump.you can`t see it,you have to feel for it
Where is the blower motor in a 1999 Oldsmobile 88?
Directly behind the engine, on the middle of the firewall.
