0
Where do you replace the Crank Position Sensor in a 1993 Oldsmobile 88 Royale?
Wiki User
∙ 18y ago
on the front of the motor under the front crank it has a plug going to the crank.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Where is camshaft position sensor located on a 2001 Oldsmobile intrigue GLS 3.5L 6cy?
See related answers
How do you repair the crank signal so that the engine will continue to run?
replace cam position sensor
What is a pintle position sensor?
a pintle position sensor tell the engine computer what the exact position of the egr valve is
How do you replace tpms on 2004 liberty?
Generally requires removing and dismounting the tire, replace TPMS sensor, remount tire, balance tire, re-install tire to vehicle, do the relearn tire position procedure.
When the transmission sensor is out on a 1998 Dodge Ram 1500 does it mean you need to replace the transmission or just the sensor?
All you need to do is replace the sensor. It cost around $20.
Where is the camshaft position sensor located on a 1999 Oldsmobile Intrigue and how do you replace it?
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
Show the location of camshaft position sensor for 2002 Oldsmobile bravada?
show location of camshaft position sensor for 2002 Oldsmobile bravada.
How do you replace a camshaft position sensor on a 90 Oldsmobile 98?
It is pretty technical and special tools are needed. Take it to a garage.
How do you replace crankshaft position sensor Oldsmobile 1988 ninety-eight?
You have to dismantle the entire engine,,,NO YOU DO NOT ITS JUST YOU HAVE TO DRAIN THE OIL TAKE THE OIL PAN OFF AND GET THAT DANG SENSOR TAKEN OUT THEN REPLACE IT!!
How do you replace the throttle position sensor in a 98 Olds intrigue?
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
How do you change a crank shaft sensor for a 93 Oldsmobile delta 88 royale?
on a 90 olds 88 royale your sensor sits inside the timing cover...will need to remove the harmonic balancer (need pulley for that) and remove two screws to take sensor out. replace all parts same way they came out and in same order. passenger side of engine in timing cover
Where is the Camshaft Position Sensor located in the 1996 Oldsmobile Achieva?
The Camshaft Position Sensor is located behind the Power Steering Pump.
How do you replace the throttle position sensor on a 97 Nissan altama?
how to replace the throttle position sensor on a 97 nissan altama
How do you replace replace the camshaft position sensor?
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
Your 1988 Oldsmobile turns over but will not start what can it be?
POSSIBLE CRANKSHAFT POSITION SENSOR.
How to replace camshaft position sensor for vw jetta 1999?
how to remplace position of oxigen sensor
Where is the camshaft position sensor located on 2001 Oldsmobile Aurora?
---------------------------------------------------------- The camshaft positioning sensor is hidden behind the starter motor on the 3.5 6-cyl. engine. I think it's the same for the 4.0. The starter motor must be removed to replace the sensor.
