Your ECM should be located on the passenger side of the car. remove the glove box and it should be on the outide wall. I am not sure that there is an acual fuse for this. but that is where the ECM is located. i hope that this is helpful.
can someone give me a diagram of a fuse box location for a 1993 Chevy beretta
Due to a over or underloaded system, ensure that the correct rated fuse is installed, over or under amperage can cause a fuse to be blown.
The ignition is not fused.
In an owners manual from MOTORLIT.COM
then there is a short some where!
check emc fuse and the fuse next to it
Autozone.com has a fuseblock diagram. Our '93 Beretta is not here for me to go put the fuse block cover on the scanner (fuel delivery problem....), but go look that up. Fuses is called "circuit protection" after you get through all the narrowing it down to 1993 Chevy Beretta Chassis Electrical....
Get a fuse panel cover at a junk yard
there is a fusable link in the wiring, but no actual fuse. the fusable link is down by the starter assembly...
Two separate items there. There is a horn fuse and a horn relay. Location can be found in the owners manual.
In a 1992 Chevy G20 van, the ignition fuse is located in the fuse box under the dashboard on the driver's side. To access it, you may need to remove a cover panel. Look for the fuse labeled "IGN" or "Ignition" in the fuse box diagram to identify the correct fuse. Always ensure the vehicle is turned off before checking or replacing any fuses.
You will often find a diagram of the fuse box for the 1988 Chevy Cheyenne in inside cover for the fuse box. This fuse box is located on the driver's side of the vehicle under the dash. The cigarette lighter fuse is generally marked as ACC.