answersLogoWhite

0

It is on the back of the intake manifold.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is code 43 1992 Chevy S10 blazer?

knock sensor


How do you adjust the idle on a 95 Chevy Blazer 43 liter V6?

it is not adjustable, it is controlled by the computer.


What is a code 43 on a 93 Chevy blazer?

ESC / Electronic Spark Controll Circuit. and the knock sensor signal.


Where can you find a schematic for the ignition control module of a 43 vortec engine in a 1994 Chevy Blazer S10?

Owners manual, positive.


What is a code 43 on a 1993 s-10 blazer?

knock sensor


What is the cause and corrective action required for pieces of carbon getting caught in the EGR valve on a Chevy S-10 with a 43 Engine?

an EGR valve gasket is available that has a screen to block the carbon. They cost $5.69 at the autoparts store in my city.


What is the 1996 43 liter v6 Chevy blazer fuel consumption?

I have a 1996 Chev Blazer. ITS A GAS HOG! Under normal city driving I get 450km with 65 litre gas. Don't feel bad my wallet is drained


1989 cheevy blazer 43 Ecm code 12?

System Normal


What standard trans fits a 98 S10 Blazer 4x4 with a 43?

any from 88 to 98


Where is iat sensor on 43 Chevy?

there isn't one.


1986 Chevy Astro Van V6 43 hesitating on take off but then runs fine after that?

I think it's your EGR Valve. The EGR valve, or Exhaust Gas Recirculation valve, is a vacuum controlled valve which allows a specific amount of your exhaust back into the intake manifold.The EGR valve, or Exhaust Gas Recirculation valve, is a vacuum controlled valve which allows a specific amount of your exhaust back into the intake manifold. You'll know if your EGR valve is stuck or malfunctioning because your car will experience symptoms like rough idle and bucking on acceleration.


Why won't your engine stay on For a 1991 Chevy Blazer S10 43 liter engine?

My 94 blazer had this problem and it was the fuel pump. My Blazer eould start and run for a few seconds and the die,after Ichanged the fuel pump it started reigt up. . Awhile back my truck wasnt staying started for more then five seconds, and it turned out that it needed the RPMs adjusted bc it wasnt high enough to keep the truck going =( didnt cost much though