0
What else can I help you with?
Where is the low side service port for a 1993 Ford Ranger?
The low pressure port on a 1993 Ford Ranger is located close to the firewall. It can be seen just under the air filter housing.
Where is the the diagnostic port on a 1993 Ford Ranger?
the diagnostic port is located behind the fuse box on the passenger side inner fender well
Where is the ObdII port located in a 2008 Ford Ranger?
On a 2008 Ford Ranger : You will find the Data Link Connector for your OBD II in the lower part of your dash , below the steering wheel , between the inside hood release and the parking brake / emergency brake release . It is behind a small plastic panel that removes ( or possibly flips up )
Where is the low pressure ac recharge port on 1993 Ford Ranger?
where is the low pressure port for the a/c -- 93 ford ranger 4.0L -- super-cab
Where is the low pressure ac recharge valve on 2000 ford ranger?
The recharge port is located on the passenger side near the firewall.
Where is the ac recharge port on a 2008 Ford F-150?
The AC recharge port on a 2008 Ford F150 is located close to the hose that runs from the compressor to the accumulator. The hose is the low-pressure hose and you will notice a service fitting on the hose which is where the port is.
Where is the scan port on a 1991 ford ranger?
The scan port is usually located under the dash, near the steering column. It may be visible, or behind a small cover that can be removed.
Where is the OBD diagnostic plug located on a 2008 Ford Escape?
The 2008 Ford Escape OBD 2 port is under driver side dash left of steering column
Where is obd plug on 2004 Ford Ranger?
The 2004 Ford Ranger OBD 2 port is under dash below or left of steering column
Where is the recharge port on 93 Ford?
where is the ac recharge port on a 93 ford explorer located?
Where is the computer hookup for 1986 Ford Ranger?
Most under dash driver's side. There isn't an OBD port on a 1986 ranger!!
Where is the diagnostic port on a 1994 Ford Ranger?
On a 1994 Ford Ranger ( which is OBD I , EEC IV ) should have an EEC TEST connection in the engine compartment ( P.S. I'm not a mechanic / technician )
