0
What else can I help you with?
Where is the low side service port for a 1993 Ford Ranger?
The low pressure port on a 1993 Ford Ranger is located close to the firewall. It can be seen just under the air filter housing.
Where is the low pressure ac recharge port on 1993 Ford Ranger?
where is the low pressure port for the a/c -- 93 ford ranger 4.0L -- super-cab
Where is the diagnostic scanner port in a 1995 Ford Ranger?
In a 1995 Ford Ranger, the diagnostic scanner port is located under the dashboard on the driver's side, typically near the steering column. You may need to remove a cover or panel to access it. The port is usually a 16-pin connector, which is used for connecting a diagnostic tool to read trouble codes.
Where is the diagnostic Center on a 94 Ford Ranger?
Should be a port inside under dash where you plug in a code reader.
Where is the diagnostic port on a 1994 Ford Ranger?
On a 1994 Ford Ranger ( which is OBD I , EEC IV ) should have an EEC TEST connection in the engine compartment ( P.S. I'm not a mechanic / technician )
Where do you locate the diagnostic port entry on a 1987 Ford Ranger?
I believe that will be found under the hood, near the windshield, drivers side.
Where is the diagnostic port on a 2000 Ford Ranger?
It is important to know all of the locations of the electrical parts in a car. The Diagnostic port of this car is found on the driver's side of the car, underneath dashboard, between the driver-side door and steering column area.
Where is the diagnostic port on 2001 Ford Laser?
kn laser port
Where is the diagnostic scanner port in ford E-150?
Where is the diagnostic scanner port on a 1995 F-250 4x4
Where is the diagnostic port on a 98 ford ranger?
Divers side between the door and steering wheel (left of steering column), its covered.http://www.nology.com/pdfandzipfiles/obdiiconnectorlocations.pdf
Where is the diagnostic port on a 1993 ford e250 van?
On a 1993 Ford E250 van, the diagnostic port, also known as the OBD-I connector, is typically located under the dashboard, near the driver's side. It can be found to the left of the steering column, close to where the dashboard meets the steering wheel. You may need to crouch down or use a flashlight to see it clearly. This port is used for connecting diagnostic tools to read trouble codes from the vehicle's onboard computer.
Where is the diagnostic port on a 1988 ford ranger?
Just to the rear of the battery is a plastic cover that is held in place with one fastener. Under the cover is a 5-sided red connector. That is the diagnostic port for the Ford EEEC-IV system. You will need a reader, or a jumper wire and an analog vom to extract the codes. tom walsh
