Where is the diagnostic scanner port on a 1995 F-250 4x4
In a 1995 Ford Ranger, the diagnostic scanner port is located under the dashboard on the driver's side, typically near the steering column. You may need to remove a cover or panel to access it. The port is usually a 16-pin connector, which is used for connecting a diagnostic tool to read trouble codes.
Look directly under the steering colunm in the passenger compartment... should be located just under the dash.
there is not a scanner port on 87 hondas, the ecu will flash the code from the led on top of the computer. dachonda
kn laser port
Reading diagnostic codes is easy. The driver plugs the reader/scanner into the diagnostic port of the vehicle, and the scanner/reader will give a code if there is a problem, and tell them the type of problem.
To retrieve diagnostic codes from a 2005 Ford F-150, you can use an OBD-II scanner. Plug the scanner into the OBD-II port, usually located under the dashboard near the driver's side. Turn the ignition to the "On" position without starting the engine, and then follow the scanner's instructions to read the trouble codes. Additionally, you can reset the codes by disconnecting the battery for a few minutes, but using a scanner is the most effective method for diagnosis.
The diagnostic port on a 94 Ford Taurus is located under the hood near the firewall usually on the driver's side. Ford started producing the Taurus in 1985.
the diagnostic port is located behind the fuse box on the passenger side inner fender well
The diagnostic port is located at the bottom of the lower dash panel to the left of the steering column.
On the left side of the steering wheel
The diagnostic port on a 1997 Mitsubishi 3000GT is located under the driver's side dashboard, near the steering column. It is typically covered by a plastic panel that may need to be removed to access the port. This OBD-I port is used for connecting a diagnostic scanner to retrieve trouble codes and perform vehicle diagnostics.
The diagnostic connector is in the engine compartment on the left hand side between the battery and the fuse box. An adapter is required to read this port with an OBD2/OBDII diagnostic tool.