In the exhaust pipe before the catalytic converter, which is right behind the engine
It is screwed into the exhaust manifold on the back of the engine.
It is a two wire sensor, very near where the upper radiator hose attaches to the engine.
The speed sensor on a 1994 Chrysler LeBaron is typically located on the transmission. Specifically, it can be found on the driver's side of the transmission, near the output shaft. To access it, you may need to remove some components or shields that obstruct visibility. Always consult a repair manual for detailed instructions and diagrams specific to your vehicle.
Chrysler ATF+4
There are two, one in each exhaust manifold.
There is one in each exhaust manifold.
4.5 quarts
RockAuto.com has auto parts and body parts for the 1994 Chrysler LeBaron at discounted and wholesaler closeout prices.
To replace the 3-prong speedometer sensor on a 1994 Chrysler LeBaron, first, disconnect the negative battery cable to ensure safety. Locate the speedometer sensor on the transmission; it typically has a wiring harness connected to it. Unplug the harness and remove the mounting bolt or screws securing the sensor, then pull it out. Install the new sensor by reversing the removal steps, ensuring it’s securely fastened, and reconnect the battery cable.
It has one oxygen sensor located on the rear exhaust manifold.
In the fuel tank.
No, it does not have a reset switch.