The 1993 Buick Le Sabre comes with a 4T60E transaxle. Go to the driver's side fender and lean over. The PRNDL switch is located on the back part of the transaxle where the engine meets with the transaxle. If you look down past your brake booster towards the transaxle you should be able to see it. It should have two sets of wire harnesses coming out of it as well as the shifter arm connected to it.
Door pin switch.
The weight of a 1993 Buick Lesabre is approximately 3,340 lbs. The Lesabre has seating for six passengers to ride comfortably.
The 1993 Buick LeSabre Limited 4 door sedan has a curb weight of 3,454 lbs.
where do the thermostat go in my 93 buick lesabre
To start a 1993 Buick LeSabre with a bad ignition switch, you can try bypassing the switch using a screwdriver or a jumper wire. Locate the ignition switch connector under the steering column and connect the appropriate wires to simulate the "start" position. However, this is a temporary solution; it’s advisable to replace the ignition switch as soon as possible for safety and reliability. Always ensure the vehicle is in a safe position before attempting to start it this way.
yes
Dealer? Locksmith?
In the sides and rear of the block.
around 5
Look at the lower rear end of the engine
help me i need this answer :- (((
Water.