In a 1996 Mercury Sable, the power window control module is typically located in the driver's door panel. To access it, you'll need to remove the door panel, which involves taking out screws and clips to reach the module. It may also be part of the window switch assembly. Always refer to a repair manual for specific instructions and diagrams for your vehicle.
The module is situated in the arm rest where you store stuff unscrew it and you will find the module.
the power control module is located on the passanger side of the car above the plate where the carpet meets the dash.
The power down module is located on the inside of the door panel itself under the armrest. If there is a problem with this module (ie unplugged, stuck etc) the driver's side window will not operate.
Check the buzzer relay and the window control module. The buzzer relay is located above the fuse box and the control module is located under the rear back seat. You may need to replace them. The power window control module can be quite expensive. Hope that helps.
The window control module in a Mercedes SLK 230 is typically located in the driver's door panel. To access it, you'll need to remove the door panel, which involves taking out screws and clips. The module is usually positioned near the window switches and wiring harnesses. If you're experiencing issues, it's advisable to consult a repair manual or a professional for detailed guidance.
located under the indash.. right side where your gas pedals are. have to open carpet. black box
To replace the window control module on a 2006 Honda CR-V, first disconnect the vehicle's battery to ensure safety. Remove the door panel by unscrewing any visible screws and carefully prying it off to access the window control module. Disconnect the wiring harness from the old module, replace it with the new module, and reassemble the door panel. Finally, reconnect the battery and test the window controls to ensure proper functionality.
Its likely it is the power window relay switch, located on the right hande side under the glove box, i think its called a kick panel, but its located behind the computer control module.
In the Mitsubishi 3000GT VR4, the power window control module is typically located in the driver's side door. To access it, you may need to remove the door panel to reach the wiring harness and module. It's important to ensure you disconnect the battery before working on electrical components to avoid any short circuits. Always consult the vehicle's service manual for specific instructions related to your model year.
In a 1999 Ford Mustang, the window module, also known as the power window relay or motor, is typically located inside the driver's side door panel. To access it, you'll need to remove the door panel, which involves taking out screws and clips. Once the panel is off, you can find the window motor and related wiring, which is connected to the window control switches. If you're experiencing issues with the windows, it may be necessary to troubleshoot this module for any faults.
The suspension control module (otherwise known as a vehicle dynamics module (VDM)) is located in the trunk underneath the dash of the rear window, almost center, slightly off to the driver side. When servicing this, BE SURE TO TURN THE IGNITION AND THE AIR SUSPENSION SERVICE SWITCH TO THE OFF POSITION. Then you will need to remove the upper trucnk compartment trim panel and lower the module tray. Disconnect the wiring harness jfrom the control module, unsnap the control module from ray clips and remove. Reverse procedure to install.
Above the headliner, near the rear window