answersLogoWhite

0

The Hydraulic Control Unit for the 1995 Ford Ranger 4 wheel anti-lock brake system 4WABS is located in the engine compartment on the left front inner fender panel. It consists of: the brake pressure control valve block, pump motor and hydraulic control unit reservoir. The "brains" of the 4WABS in the Ranger is the Brake Control Module, or Electronic Control Unit (ECU). The ECU/Brake Control Module is mounted in front of the right front corner of the battery on the radiator support.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where is the wiper control module located on the 1997 ford ranger?

In a 1997 Ford Ranger, the wiper control module is located behind the radio compartment. It sits on the left side of the compartment.


Where is the ignition module located on a Ford Ranger XLT 2.3l?

1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.


Where is the 4x4 control module located on 1994 ford ranger?

somewhere in the cab, probably behind the seats


Where is the electronic shift control module located on a 2001 Ford Ranger XLT?

it is found on the passenger side kick panel also called a 4x4 control module


Where is the ignition module located on a 1989 ford ranger?

The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is the ecm on a 1987 Ford Ranger?

the engine control module (ecm) is located behind the passanger kick pannel. which is located by the floor, passanger side.


Where is the pcm located on a 93 ford ranger 2wd manual v6 3.0?

Driver side on firewall behind cruise control module


Where is the pcm relay on a 2001 Ford Ranger?

On a 2001 Ford Ranger : In the Power Distribution Box ( which is " live " ) located in the engine compartment , on the drivers side ( the # 54 relay is the relay for the Powertrain Control Module / PCM )


Where is the cruise control module located on 2001 ford ranger?

On a 2001 Ford Ranger, the cruise control module is typically located under the dashboard on the driver's side, near the steering column. It may be mounted to the firewall or attached to the vehicle's wiring harness. For precise access, it's best to consult the vehicle’s service manual or a repair guide.


Where is the ignition control module located on a 1997 ford ranger 2.3L?

On a 1997 Ford Ranger 2.3L, the ignition control module is typically located on the driver's side of the engine compartment, near the firewall. It is mounted on the ignition coil bracket, which is situated on the side of the engine. To access it, you may need to remove some components for better visibility and reach.


Where is the alarm module located on a 1999 Ford Ranger?

it is not an alarm module it is called a G.E.M. module,and it located behind the radio in the dash.and to replaced it has to be reprogrammed


Where is the four wheel drive module located at on a 2002 mercury mountaineer?

Check behind the glove compartment. The TCCM (Transfer Case Control Module) is located there on some Ford vehicles like the Exploder and the Ranger.