it is above the gas peddle. Its blue and it has black foam wrapped around it. It is mounted vertical and pulls down with ease.
The airbag module for the 1997 Ford F150 is located in the passenger side kick panel below the dash. It is silver and black in coloring.
On the distributor
Powertrain Control Module ( PCM )
The ignition control module for a 1995 ford f150 is an important part of the drive train. If the module is failing then the engine will run erratically or not start at all.
To repair airbag code 34 on a 2004 Ford F-150, first, inspect the passenger side airbag circuit for any faults, particularly the connection at the airbag module and the wiring harness. Ensure that the airbag module is securely connected and that there are no damaged wires. If necessary, clear the code using an OBD-II scanner and check if it returns. If the issue persists, it may need further diagnostic testing or replacement of the airbag module.
under the dist. cap
under the dash, above the radio. take out speedometer module to get to it
The cruise control relay on a 1994 F150 is operated by a switch behind the horn pad and airbag on the steering wheel. The switch will probably need replacement if the cruise control in your vehicle is malfunctioning.
The power control module (PCM) is the brain of the vehicles engine functions. The relay is a module as part of its power supply circuit.
The airbag computer module on a 2006 Ford F-150 is typically located under the center console, near the transmission tunnel. It may also be found behind the dashboard or under the driver's seat, depending on the specific configuration of the vehicle. Accessing it usually requires removing panels or components for better visibility. Always refer to the vehicle’s service manual for the most accurate information and instructions.
it is in the center of the dash, below the radio, behind the black cover at the floor. it is the piece on the very bottom, held in with 3 green bolts. literally JUST removed mine from a 99 f-150
VSS WIRE Gray/black At Powertrain Control Module Pin 68