0
In a 1994 Jeep, the ballast resistor is typically located in the engine compartment, mounted to the firewall or near the ignition coil. It is part of the ignition system and helps regulate voltage to the ignition coil, ensuring proper engine operation. If you're having trouble locating it, consult the vehicle's service manual for more specific guidance.
What else can I help you with?
Where is the ballast resistor for a 1994 Jeep Cherokee?
It does not have an ignition ballast resistor.It does not have an ignition ballast resistor.
Where is the fuel tank ballast resistor in a 1999 Jeep Cherokee?
There is no such part on a 1999 Jeep Cherokee.
Where is 2001 jeep wrangler blower motor resistor located?
Where is the resistor on 2001 jeep wrangler
Where is the cigarette lighter fuse located on a 1994 Jeep Cherokee?
Where is the cigarette lighter fuse on a 1994 jeep grand cherokee located
Where is the blower motor resistor located on a 2004 RHD Tj Jeep wrangler?
in your but
Where is the blower resistor block located on a 2003 Jeep liberty?
behind the glove box
Where is the fuel pump ballast resitor located. on 94 jeep cherokee larado 4.0 4wd?
Top, drivers side fender
Where is the transmission located on a 1994 Jeep Wrangler?
It is directly behind engine.
Were is the horn on a 1994 Jeep Cherokee located?
Right behind the grill
Where is the cam sensor located on a 1994 jeep Cherokee?
It is inside the distributor.
Where is the blower motor resistor located on a 1999 Jeep Wrangler and where do you get a new one?
The motor is located under the glove compartment. There is a housing next to the floor light with 4 screws. Remove the housing and the resistor should be a gray plastic with two screws holding it in. you have to go directly to the jeep dealer for a new one
Where is the blower motor resistor pack located on a Jeep Cherokee?
On my 1994 Cherokee, it is located under the dash on the passenger side. It will be on the air box by the air exchanger, held on by 2 screws. Simple replacement. Bought one off eBay for $14. All speeds are working now.
