The ballast resistor is on the left side inner fender.
The ballast resistor is located on the left inner fender.
The ballast resistor is located either on the firewall or on the left inner fender.
Yes it can. If there is a bad wire in your harness the ballast resistor will get hot, in which causes your coil to overheat and cut out or burn outline.
bad ballast resister
On a 1978 Dodge D100, the ignition resistor is typically located on the firewall, near the passenger side. It is a small rectangular component that can be mounted on a bracket. Its purpose is to reduce voltage to the ignition coil to prevent overheating. If you're having trouble locating it, consult the vehicle's service manual for a detailed diagram.
If you have no spark, check the ignition coil and ballast resistor. If the engine tries to fire when you turn the key to off position, there may be a short in the ignition switch.
It is either a 22 or 30 gallon tank.
Left exhaust manifold.
Hey; Check the ballist resistor, and the voltage regulator. Unidrv
Can't by pass.Put a new control unit on
Facing the front of the truck, it is located on the intake manifold on the right side of the carb.
i have a 87 but i think they are the same. mine is located right below the steering column.