The ballast resistor is located either on the firewall or on the left inner fender.
The ballast resistor is located on the left inner fender.
The ballast resistor is on the left side inner fender.
On a 1978 Dodge D100, the ignition resistor is typically located on the firewall, near the passenger side. It is a small rectangular component that can be mounted on a bracket. Its purpose is to reduce voltage to the ignition coil to prevent overheating. If you're having trouble locating it, consult the vehicle's service manual for a detailed diagram.
hi i have dodge sweptline d100-1969 please i need chromrear bumper thanks hussain440
Hey; Check the ballist resistor, and the voltage regulator. Unidrv
The horsepower of a 1967 Dodge D D100 is approximately 258 hp.
when my 1986 w-250 turn signal switch went out the brake lights quit working.
Facing the front of the truck, it is located on the intake manifold on the right side of the carb.
i have a 87 but i think they are the same. mine is located right below the steering column.
I am not sure of how to instal a rear main seal on '89 dodge D100 with a v6.
bad ground or electronic box/ballest resistor (white porcline box) is bad depending on what month it was manufactured it might have a fuel or spark control computer and still have the holley 2 bbl carburetor on drivers side inner fender
5x5.5