0
What else can I help you with?
Where are the bolts on a 5.0 mustang starter?
the starter is located on the bellhousing towards the passenger side
Can a 1985 mustang transmission fit in a 1990 mustang?
Yes! if its just the transmission, and no bellhousing, its a 25 minute swap, i think there might be about 8 or 9 bolts to remove including the driveshaft.
Can a large bellhousing c4 tranny be swapped with a small bellhousing c4?
yes i just went from a small bell housing to a large bell housing in my mustang it works. the flexplate motor plate and converter has to be used with that tranny.
How many times does 50 go into 91?
50/91
Will the front seats from a 1989 mustang V6 fit a 1991 mustang gt?
Yes the front seats from a 89 mustang v6 will fit in a 91 mustang, the tracks are the same.
What color is the negative coil wire on a 91 mustang?
green.
Can a small block Chevy fit in a 91 mustang?
Yes.
What is 50 over 91 simplified?
50/91 is already simplified.
What is 91 over 50 as a percent?
91 over 50 as a percent = 182%% rate:= 91/50 * 100%= 1.82 * 100%= 182%
Where is the starter located on a 1990 Ford Mustang?
If it's the 5.0 model, it's to the left (looking at the front of the car) of the transmission bellhousing underneath the car.
Can a T5 transmission be put into a 200 ci V6 3-speed 67 Mustang?
It is doubtful as the bolt pattern on the bellhousing is most likely different.
How do you replace a clutch slave cylinder on a 1991 YJ Wrangler?
You will have to remove the transmission since the slave cylinder on the 91 yj is inside the bellhousing.
