Has anyone ever really been far even as decided to use the belt tensioner on 93 plymouth ranger even go want to do look more like?
The 93 Acclaim has a serpentine belt. The tensioner below the alternator is what keeps the tension. If you have not tension I would replace the belt first and then check the tensioner.
No.
The tensioner has a spring in it that provides the correct tension for the belt. If it is too loose, replace the tensioner.
find the belt tensioner and use a rachet to oush the tensioner back
The towing capacity for the 1993 Plymouth Voyager is about 2000 pounds. This varies somewhat depending on the model purchased.
Had that same problem on my 93 the tensioner wore out. had to have it replaced.
On my '93 Voyager the jack is located in the engine bay, left hand side near the prop rod.
Lossen 17 mm bolt at botton of tensioner and screw 13mm bolt on tensioner stud untill belt is tight then re torque 17mm bolt !!
is there a way to fix or replace just the rubber in the mount
To loosen the serpentine belt tensioner on a 1993 Chevy Silverado, you'll need to use a wrench or ratchet on the tensioner bolt. Turn the tensioner counterclockwise to relieve tension on the belt. Once the tension is relieved, you can remove the serpentine belt from the pulleys. Make sure to note the belt routing for reinstallation.
lokks to be on the lower right side of engine
rotate the tensioner clockwise to release the tension and remove the belt then slowly release the tensioner. route new belt over the various pulleys according to the diagram under the hood again rotating the tensioner as to allow belt to fit in place and then slowly release the tensioner again.