I have a 98 Jimmy slt and mine was located behind the glove box and to the upper left. It was really not that hard to remove.
The glove box folds down easily. I had to remove this round looking component and swing it toward the drivers side and then use a 7/32 socket to remove the two screws. Remove the power plug ,Wiggle the actuator upwards until free.There are a couple of small vacuum lines that have to be removed in the process also.
I am a mother and grandmother .If I can do it so can you!
The air door actuator on a 1998 GMC Jimmy is located in the dash. It is located behind the glove box.
need to know were the blend door actuator is for a 2002 gmc yukon on the drivers side , dual climate controls, rear air and heat
bs
The blend door actuator on a 2000 GMC Jimmy is typically located behind the dashboard, near the heater box. To access it, you may need to remove the lower dashboard panel and possibly the center console. The actuator is attached to the heater box and controls the flow of air between the heater and the air conditioning. It's advisable to consult a repair manual for detailed instructions and diagrams specific to your model.
The temperature valve actuator is located on the front of the heater case
To replace the blend door actuator in a 1995 GMC Sonoma, first disconnect the negative battery terminal to ensure safety. Remove the dashboard trim and any necessary panels to access the actuator, which is typically located behind the dashboard on the HVAC module. Unplug the actuator's electrical connector, unbolt it from its mounting, and then install the new actuator by reversing the removal process. Finally, reconnect the battery and test the operation of the new actuator.
The blend door actuator in a 1999 GMC Envoy is typically located behind the dashboard, near the heater core. To access it, you may need to remove the lower dash panel and possibly the center console, depending on the specific configuration. The actuator is usually mounted on the HVAC housing, and it controls the airflow temperature by adjusting the blend door. If you're having trouble locating it, consulting a repair manual or seeking assistance from a professional may be helpful.
The blend door actuator on a 2002 GMC Sonoma is typically located behind the dashboard, near the center console area. To access it, you'll often need to remove the glove box and possibly some panels to reach the HVAC housing. The actuator is usually mounted on the side of the heater box and is responsible for controlling the temperature of the air entering the cabin.
The blend door actuator in a 1997 GMC Sonoma is located behind the dashboard, typically near the center of the vehicle, attached to the heater box. To access it, you may need to remove the dashboard or at least the lower dash panel, as it is not easily reachable from under the hood. The actuator controls the flow of air between the heater and the air conditioning system to adjust the temperature inside the cabin.
The blend door actuator on a 2000 GMC Yukon XL 1500 is typically located behind the dashboard, near the heater core and the air conditioning unit. Specifically, it can be found on the passenger side of the vehicle, often requiring the removal of the lower dash panel for access. It's advisable to consult a repair manual for detailed instructions and diagrams to assist in locating and servicing the actuator.
Take out the battery and the battery tray. Its underneath the two on my jimmy.
Could be the temp blend door actuator with stripped gears (the gears are made out of plastic). Or, the squirrel cage for the blower has debris in it and it is out of balance.