The blower motor on a 2001 Chevy Metro is typically located behind the dashboard on the passenger side, near the firewall. To replace it, first disconnect the battery, then remove the passenger side lower dash panel for access. Unplug the electrical connector, remove the retaining screws, and carefully pull out the blower motor. Install the new motor by reversing these steps, ensuring all connections are secure.
where is the blower motor on a 2001 chevy blazer
Location of blower fan on 2001 blazer
The bearings are out of it. Replace Blower motor.
Check to see if you are getting power to blower motor - if so replace blower motor If not check fuse, switch, resistor pack.
To replace a blower motor on the resistor first you take off the nozzle and then you go into the motor through the nozzle and unlock it then repeat and oil and done.
To replace the blower motor on a 2001 Hyundai XG300, first disconnect the negative battery terminal. Then, remove the lower dashboard panel to access the blower motor, which is located behind the glove compartment. Disconnect the wiring harness and unscrew the motor from its housing. Finally, install the new blower motor, reattach the wiring, and replace the dashboard panel before reconnecting the battery.
To replace the blower motor on a 2001 Mitsubishi Eclipse, first disconnect the negative battery cable to ensure safety. Remove the blower motor cover and unplug the electrical connector from the motor. Unscrew the mounting screws holding the blower motor in place, then carefully pull it out. Install the new blower motor by reversing these steps, ensuring all connections are secure before reconnecting the battery.
The resister for the 2001 prism blower motor drops voltage to the blower motor. This is how the blower motor runs at a lower speed.
You need to replace blower motor resistor.
replace the blower motor resistor
you have waisted my time, thank you
Disconnect the battery and remove the glove box, lower finish panel and ECM. Disconnect the blower motor wire harness and the three mounting screws.. Remove the blower motor.....