brake caliper bushings are the rubber mounts that sit inside the caliper bolt holes. They help guide the bolts when bolting the caliper up to the caliper bracket.
Trailblazer enthusiasts will cover all the subjects including brake jobs at www.trailvoy.com
No, the 2004 Durango is a completely different brake system.
Hose?
take off the tire and the caliper and the rotor just slides off
70
To remove the brake calipers on a 2004 Mercury Monterey, start by safely lifting the vehicle and removing the wheel. Next, locate the caliper bolts on the back of the caliper and use a socket wrench to remove them. Once the bolts are removed, carefully slide the caliper off the brake rotor, and support it to avoid straining the brake line. Finally, if necessary, disconnect the brake line from the caliper for complete removal.
Remove the caliper retaining bolts from the inside of the caliper. Lift the caliper off the mounting bracket and over the rotor. Slide the old inner and outer brake pads out of the caliper, and slide the new brake pads into the caliper.
Yes.
Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Slide in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car.
Lift the vehicle, remove the tire, remove the brake shoe/caliper, and remove the old brake pad. Put in a new brake pad, replace the brake shoe/caliper, replace the tire, and then lower the vehicle.
Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car.
You have to take off the caliper and rotor and adjust the brake with a flat head screwdriver