answersLogoWhite

0

The powertrain control module (PCM) is located in the passengers side kick panel area of the S-10 with the 4.3L engine. If that S-10 has the 2.8L or the 2.5L engine it would have an electronic control module (ECM) also located in the passengers side kick panel area.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the general control module on a type-s?

What does the general control module control


How do you change the Ignition Control Module in a 1995 Blazer S-10?

Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.


How do you replace a 1994 Chevy S-10 blazer transfer case control module?

where is it at


Where is the general control module on a jaguar type-s?

What does the general control module control


Were is the ingition control module on your 1985 Chevy s-10 2.8?

The ign. control module on a 2.8L s10 is in the distributor. Remove the distributor cap and it is attached to the base of the distributor


Where is the ECU in a 1995 S-10?

The PCM (Powertrain Control Module) would be found in the passenger side kick panel area in that 1995 S-10.


Where is the airbag control module located on a 2001 s-10?

I have a 2001 s-10 ext cab with 60-40 front seats. The module was located under the 20% of the drivers seat where a center console would be. It was under the carpet. I had to cut the carpet to get to it. Hope this helps.


Where is the ignition control module located on a 1992 Chevy S-10 Pickup?

The Distributer module on "92" S-10 Vin code "W" or "Z" is located on the distributer,you must remove the distributer cap to gain access to the ignition module. Once you have gained access to the ignition rotor it is always necessary to always test the module before replacing it.


Is the ecu and ecm the same part for a 91 Chevy S-10?

The ecm is the engine control module. I'm not sure what a ecu is.


Where is electroni control module 01 Chevy s 10?

pass side under hood just behind the coolant res. tank!!


How do you change a door control module on Mercedes s class?

unplug it


Where is the ignition module on a 1999 4 cylinder Chevy S 10?

The 1999 Chevy S 10 pickup truck ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

Trending Questions
What is the engine oil capacity for a 2004 f150 5.4 8 cylinder engine? How much do you have to weigh to to sit in the front seat in Ohio? What size torx bit is needed to remove bumper bolts on a 2004 jeep wrangler? How do you disable the security system on a 1997 Jeep Wrangler? How much do a processor error module for 2007 dodge charger? How do you set clock on 1990 dodge ram van? How do you remove the taillight on a 2002 Ford F-150 XLT Supercrew? What is the weight of a 1987camaro z28? What transmission oil is used for a 1992 chev S10 truck with 4 spd manual transmission? 2003 Avalanche has a loss of power when you let off on the accelerator causing the lights to dim. Heater slows and the tach goes down around 500rpm.It has stalled under these conditions.Why? How do you remove a brake booster off a 2005 Buick lacrosse? Can you show me the wiring diagram for a 1984 Chevrolet truck? How to no if my fuel punp goimg out on 2001 Ford Focus? 2003 Yukon XL quit running while going 60 mph for no reason what could it be? Why is your 1995 Geo Prizm squealing? Do you need a new idle speed control motor? What is the labor on knock sensors for 03 Chevy Avalanche? Where is the alarm reset button on a Dodge Journey? Where is it possible to find the estimated price of a 2009 Chevy Silverado? If both inside buttons that open the sliding doors on a 2001 TC have stopped working but child safety locks are not the problem and the doors do open from the remote or the console what could be wrong?