On a 2003 Pontiac Vibe, the coolant temperature sensor is typically located near the thermostat housing, which is generally at the engine end of the upper radiator hose. It may be positioned on the engine block or intake manifold, often at the front or side for easy access. To locate it precisely, refer to the vehicle's service manual or consult a repair guide.
No such animal . . . Vibe was released in 2003
The air intake temperature sensor on a 2003 Vibe is located in the hose that connects to the air cleaner. It is near the end of the part of the hose that connects the air cleaner to the carburetor.
The ambient air temperature sensor on a 2003 Pontiac Vibe is typically located in the front of the vehicle, often near the front grille or behind the bumper. It may be mounted on the radiator support or near the air intake. For precise location, it's advisable to consult the vehicle's service manual or a repair guide.
The coolant temperature sensor on a Pontiac Vibe with a 1ZZ engine is typically located near the thermostat housing. It is mounted on the engine block, usually on the driver's side, near the top of the engine. You may need to remove some components for better access, but it is generally accessible from the top of the engine bay. Always refer to the service manual for specific details and diagrams.
first try cleaning your mass air flow sensor.
For a 2003 Pontiac Vibe, it is recommended to use a 50/50 mixture of distilled water and ethylene glycol-based antifreeze, which meets the GM Specification GM6091M. A good choice is an orange or green coolant that is compatible with Dex-Cool, as the Vibe shares components with other GM vehicles. Always check the owner’s manual for specific recommendations and ensure the coolant is suitable for your climate conditions.
is there a video on how to change the starter for a 2003 vibe
There are two o2 sensors one before the converter and one after. There is a TSB (technical service bulletin) on the vibe o2 sensor. Depending on your milage your car may be covered. The heated sensor (sensor 1) is on the exhaust behind the engine. Trouble codes would be P0171 and P2195 for the TSB/recall.
To replace the O2 sensor in a 2003 Pontiac Vibe, first, ensure the engine is cool and disconnect the battery for safety. Locate the O2 sensor, which is typically found on the exhaust manifold or downstream in the exhaust system. Use an O2 sensor socket or a wrench to unscrew the old sensor, then install the new sensor by threading it in and tightening it securely. Finally, reconnect the battery and check for any error codes with an OBD-II scanner to ensure proper installation.
Check your ambient light sensor. In American vehicles I have only seen the sensor on top of the dashboard. It looks like a little bubble sticking up.
The 1.8 liter four cylinder in a 2003 Pontiac Vibe has a timing CHAIN
The speed sensor is on the transmission.