On the drivers side low on the motor and to the rear. It is the only wire in that area. It is held on by a single bolt. Len On the drivers side low on the motor and to the rear. It is the only wire in that area.
http://www.cadillacforums.com/forums/cadillac-catera-cimarron-forum/67854-98-catera-crankshaft-position-sensor-replacement.html
Check your crank shaft sensor first.
where is the crankshaft angle sensor located on a 1997 cadillac deville.
Will it start after setting awhile? Check the crank shaft sensor.
On the low rear of the engine. It can be accessed from under the car only. It is held on by a single bolt. Len
If you have to crank and crank to get it started look for the coolant temperature sensor and change it. This is just one reason for hard start and is the most popular reason. Other reasons could be plugs, plug wires, coil pack, crank sensor, cam sensor and more.
Where is the crank position sensor hole on a 2003 Blazer
I just had to replace my Crankshaft position sensor and the part was $48 and the labor was $106. To answer your question, yes.
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.
The V6 in the Saturn VUE is sideways (FWD) vs. the version used in the Cadillac Catera (RWD). On the Saturn, the crank sensor is mounted on the front side of the engine, sort of near where the trans mounts to the engine. Pretty easy to change.
The crank position sensor is on the front of the engine. It is behind the crank pulley on the left side.