answersLogoWhite

0

The crankshaft position sensor is located on the transaxle bell housing. It may be partially obscured from view by the exhaust crossover tube.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you change a crankshaft position sensor in a 1997 Oldsmobile Regency?

1. remove positive battery cable. 2. Remove the serpentine belt. 3. remove harmonic balancer. 4. remove timing cover. 5. remove wiring connector from c.p. senser. 6. remove c.p. senser. 7. reassemble in same order as disassembled.


Where is the camshaft position sensor located on a 2006 dodge stratus?

Where is a camshaft position senser located on a 2006 dodge durango/


What would cause an 1989 firebird to stall at idle?

It can be one of these 3 things...1 Throttle position sensor..2 Mass airflow senser...3 Map senser


Where exactly is the crankshaft sensor located on a '92 Buick Lesabre?

The dual Crankshaft Position (CKP) sensor is mounted to the front of the engine, attached to an aluminum bracket mounted to the left side of the engine at the timing chain cover. A 4-wire connector plugs into the sensor, connecting it to the ignition control module.AnswerThe crankshaft senser is located under the dampener pulley. Remove the serpentine belt. Remove right front wheel. Remove plastic access cover that's behind that wheel. With an impact wrench remove dampener pulley bolt. With an Dampener pulley puller remove pulley. There is a plastic cover that snaps in place over the senser, remove it, and you will have access to the senser.Eric


What does code po341 mean on a 1997 chey s10 4 cylinder 2.2?

camshaft position senser out of range


Where is the camshaft sensor located on a 2006 dodge stratus?

Where is a camshaft position senser located on a 2006 Dodge durango/


What is isp senser?

It isn't an "isp senser" it is an "ips sensor" and it is a security software


When was Ryan Senser born?

Ryan Senser was born on 1984-07-21.


When was Joe Senser born?

Joe Senser was born on 1956-08-18.


Where is the mass air flow senser?

where is the massive air flow senser located on 2002 chrysler concord


What is the possibe causes of po300?

location of o2 senser bank senser 2 2003 jeep liberty


Where is the knock sensor in 1998 villager?

I have a 1999 villager with check engine light on. Analysis of the codes indicates faulty knock sensor. I have not replaced it yet but according to the Haynes manual it is under the intake manifold.Upper and lower intake manifolds must be removed for access. If I learn anything else interesting when I get into the replacement I will send info. My 1999 Villager may have the same knock senser problerm and the fault code is "PO325, 1 of 4, 1 Circuit malfunction bank 1 or 1 senser". I am not likely to spend $500 on it since the knock senser applied only after 1990 and it is not that important as others. Am I right? Twoo weeks ago, I got PO400 and PO325 from my 97 Villager, the problem was caused by a hose off from behind the engine. Puting it back and cleaning up the codes solved the problem and this costs $24+tax. The po325 is cause by a weak hose behind the egr. The po400 can be caused by a motor mount, misfire. If the engine moves while you power brake(in drive with foot on brake) you probably need a mount .