answersLogoWhite

0

Under the rear of the trannsmission. It's sort of below the firewall just slightly off to the passanger side. Your going to need to get underneath to get to it. It's not too bad of a job ~1 hour, give or take 15 min.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the crankshaft sensor in a 98 Montero sport?

The 1998 Montero Sport crankshaft sensor will be located on the rear of the engine. The crankshaft sensor is on the inside of the rear engine cover.


Where is the cam shaft sensor located on a 1997 jeep Cherokee sport?

The cam sensor is inside the distributor.


Where is the cam shaft position sensor located on a 1996 Cherokee sport 4.0?

The cam sensor is inside the distributor.


Where is the oil pressure sensor located on a 1997 jeep Cherokee sport?

it is right next to the oil filter


Where is crankshaft sensor 2000 mercury village sport?

The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.


O2 sensor relay location on 1996 Jeep Cherokee 4.0?

location of relay for heated o2 sensor 1999 jeep Cherokee sport


Where is the oil sensor on a 1993 Jeep Cherokee Sport?

it is located in the distributor base. look above/right of the oil filter. for a 4 liter engine


What could be the problem with a 1994 Jeep Cherokee sport that ran the night before but now will not turn over Battery has power.?

You may need to replace the crankshaft position sensor. Not sure about the '94 but I have a 2000 that had this same problem. Replaced the sensor and the problem was solved.


Where is the crankshaft position sensor located on a 1999 Dodge Dakota Sport 3.9 V6 Magnum 4X4?

On a 1999 Dodge Dakota Sport 3.9 V6 Magnum 4X4, the crankshaft position sensor is typically located near the rear of the engine, mounted on the engine block or transmission bell housing. It is often positioned close to the flywheel or flexplate, allowing it to read the crankshaft's position. To access it, you may need to remove some components for better visibility and reach.


Where is the crankshaft sensor on a 2003 jeep liberty sport?

On a 2003 Jeep Liberty Sport, the crankshaft position sensor is located on the engine block, near the transmission bell housing. It is typically found on the driver's side, close to the oil pan. To access it, you may need to remove some components or trim to reach the sensor properly. Always refer to a repair manual for specific guidance on your vehicle.


How many 02 sensor are on a 1994 Jeep Cherokee Sport?

Just one.


Where is the IAT sensor located on a 1999 Jeep Cherokee sport with a 4.0 engine?

The IAT, Intake Air Temperature, sensor is located in the air filter box. Look for it to be plugged in to the side of the air cleaner box with a wired connector going to it.