0
On a 1999 GMC Suburban with a 5.7L engine, the crankshaft position sensor is typically located on the engine's lower front, near the crankshaft pulley. It is mounted near the oil pan on the driver's side and is accessible from underneath the vehicle. The sensor is usually held in place by a bolt and connected to the engine's wiring harness. Always refer to a repair manual for specific details and diagrams for your model.
What else can I help you with?
Where is the crankshaft sensor for a 1995 gmc jimmy?
The crankshaft sensor is by the crankshaft pullie (the balancer)
Where is the abs sensor on a 95 GMC suburban located?
they are inside the front wheel hubs, on both sides.
Gmc 2002 Yukon crankshaft position sensor location?
I have been having problems with finding the crankshaft sensor, what should i do or what can i do?
Where is the fuel sensor located for a 1998 GMC Suburban?
It is on the fuel pump sending unit that's inside of the gas tank.
Where location of a camshaft sensor GMC Sonoma 95 4.3 V6 Vortec?
The sensor is down on the front of the oil pan just behind the crankshaft pully, which is located at the front of the engine.
Where is crankshaft position sensor located on 2000 gmc safari awd 4.3 engine?
Front, lower, passenger side of engine.
Where is the bank 2 oxygen sensor located on a 1994 gmc suburban?
If it has a bank two, It would be on the passenger side. I have a 1994 K2500, it only has one oxygen sensor.
Where is the map sensor located in 2005 gmc envoy?
where is the map sensor located on a 2005 gmc envoy
Where is the crank shaft position sensor on a 1999 gmc safari van?
The CPS is located on the front of the engine attached to the harmonic balancer on the front of the crankshaft.
Where is the crankshaft position sensor located on a 2002 gmc sonoma?
On a 2002 GMC Sonoma, the crankshaft position sensor is typically located near the bottom of the engine, mounted on the engine block. It is often found close to the crankshaft pulley or flywheel, on the driver's side of the engine. To access it, you may need to remove some components, such as the air intake or other obstructive parts. Always refer to a service manual for specific details and guidance.
Where is the coolant temperature sensor on a 1995 gmc suburban?
The Coolant Temperature Sensor is located right between the # 1 and 3 spark plugs (they are on the drivers side the two most forward plugs).
Where is the crank shaft sensor located on a 1986 GMC Vandura 3500 with a 350 engine?
On a 1986 GMC Vandura 3500 with a 350 engine, the crankshaft position sensor is typically located near the bottom front of the engine, close to the crankshaft itself. However, it's important to note that models from this era may not have a crankshaft position sensor, as they often relied on mechanical systems for ignition timing. If your specific model does have one, check near the harmonic balancer or flywheel area for the sensor. Always consult the vehicle's service manual for precise location and specifications.
