0
I've just cleaned the EGR valve on my 1999 Sebring Convertible. The EGR valve is over by the battery. Look from the front for something that resembles a thermostat.
Old Answer
I have a 98 lxi V6. I believe the 3.0 liter is layed out in the same fashion. If it is, the valve is attached to the back of the intake plenum(the big silver thing that looks like 6 tubes stuck together) between the plenum and the firewall. Go to an autoparts store and buy a manual for the sebring. The directions are in there. That is how I did it. Hope this helps.
What else can I help you with?
On a 1999 Chrysler sebring would the egr valve cause the car not to start?
Start and stall out, possibly. Not start at all, not likely.
Where is the EGR valve located on a 1995 Chrysler Sebring?
It's behind the manifold on the driver side
How do you change an EGI valve in a 1997 6 cylinder Chrysler Sebring?
EGI.. do you mean EGR?
Chrysler sebring egr valve location?
on a 2.5l it is mounted on the intake plennum in the back against the firewall
Where is Egr location on a 2004 Chrysler sebring?
The EGR valve is mounted on the rear of the engine. It is connected to two pipes, just above the bell housing.
How do you change egr valve Chrysler sebring 1998 2.5 liter?
You need to take the intake manifold off and radiator
1999 chrysler town and country what causes EGR error code insufficient flow?
Plugged egr tube or a failed egr valve.
Show a picture of EGR valve on a Chrysler Cirrus?
see link for pic of a Chrysler egr valve.
Where is the egr valve on a Chrysler Pacifica?
The egr valve on a Chrysler Pacifica is on the front of the engine. It is near the top, behind the water pump.
1999 cavalier change egr valve?
where do I find the egr valve on a 1999 Chevy Cavalier?
How do you replace the exhaust gas recirculation control circuit on a 2002 Chrysler Sebring?
To replace the exhaust gas recirculation (EGR) control circuit on a 2002 Chrysler Sebring, start by disconnecting the battery to ensure safety. Locate the EGR valve and its associated wiring harness; remove the EGR valve from the intake manifold by unscrewing the bolts. Inspect and replace any damaged wiring in the control circuit, then install the new EGR valve and reconnect the wiring harness before reattaching the battery. Finally, clear any diagnostic trouble codes with a scan tool to reset the system.
Where is the egr valve on a 1999 Dodge Ram?
It does not have EGR.
