under pedal left side up in dash
Bad switch on the emergency brake handle.
The 1994 Toyota Camry emergency brake light switch can be found beneath the drivers side dashboard. The emergency brake light switch will be beneath the far left hand side of the dashboard.
The emergency brake must be on for the top to open. If the brake light on the dash does not come on with the emergency brake on then you will need to replace the switch on the emergency brake.
The emergency brake must be on for the top to open. If the brake light on the dash does not come on with the emergency brake on then you will need to replace the switch on the emergency brake.
The light should be controlled by a switch operated by the emergency brake handle. The switch could be out of adjustment or could be bad.
It could be something as simple as a faulty or out of adjustment emergency brake switch. If that's not it, it could be the ABS. Often when the ABS fails the computer will turn on the emergency brake light.
To replace the emergency brake light switch on a Mercedes E320, first, locate the switch under the dashboard near the emergency brake lever. Disconnect the wiring harness from the old switch, then remove it by unscrewing or unclipping it. Install the new switch by securing it in place and reconnecting the wiring harness. Finally, test the brake lights to ensure the new switch is functioning correctly.
Usually located at the bottom of the emergency brake handle - may have to remove trim for access
Normally that light is an indication there is a problem with the brake system and MOST of the time that is low on brake fluid. There is a possibility (though remote) there is a problem with the switch on the emergency brake pedal.
your switch my need adjusted or replaced
first check your brake fluid it may be low then check the switch at the emergency brake lever it may be stuck
Brake fluid might be low, or the switch for the emergency brake may be shorted to ground (making the car think that the emergency brake is on).