Under the dash close to the steering column.
To remove the flasher relay fuse on a 2000 Chrysler LHS, first locate the fuse box, which is typically found under the dashboard on the driver's side. Open the fuse box cover and identify the flasher relay, usually labeled in the diagram on the cover. Carefully pull the relay straight out of its socket using your fingers or a pair of pliers for better grip. Ensure the vehicle is off before proceeding to avoid any electrical issues.
A Chrysler LHS does not have a reset button.
its under the steering wheel
The fuel pump in a 1995 Chrysler LHS is in the fuel tank. There is an access panel under the carpet in the trunk.
5x114.3
in the fuse box That's not the relay fuse, the relay fuse is a big black with 4 or5 prong box located under the steering column. You must disable the airbag system 1st prior to removing this fuse.
Are you sure you replaced the Turn Signal Flasher Relay? Some vehicles has a relay for the turn signals and one for the hazard lights. Possibly you changed the wrong one. It is also possible you purchased a new defective part. It happens although rarely.
There is no sensor. There is a turn signal flasher relay and hazard flasher relay. They are located somewhere under the dash. Where I could not say. You just have to look for them. Look in your owner's manual, and it may list the location. If not go to www.autozone.com and use the component location tool.
Lower driver side of the engine.
.035 inch
The relay switch in a Chrysler LHS is typically located in the fuse box, which is usually found under the dashboard on the driver's side or in the engine compartment. The specific relay you are looking for may vary depending on its function, such as the fuel pump or starter relay. It's best to consult the owner's manual for the exact location and identification of the relay in question.
Remove the wiring harness from the back of your 1995 Chrysler LHS alternator. Remove the alternator belt. Remove the alternator retaining bolts. The alternator will come off and can be replaced with the new alternator.