The fuel filter is on the underside of the vehicle on the inside of the left frame rail approximately under the drivers door.
For a 2000 Ford Excursion : ( 166.6 litres / 44.0 U.S. gallons )
To change the fuel filter on a 2000 Ford Excursion, first, relieve the fuel system pressure by removing the fuel pump relay and running the engine until it stalls. Next, locate the fuel filter, which is typically found along the frame rail. Disconnect the fuel lines from the filter using appropriate tools, then remove the filter from its mounting bracket. Finally, install the new filter in the same orientation, reconnect the fuel lines, and replace the fuel pump relay before starting the engine to check for leaks.
Horse shoe type clips? Slide filter on to fuel lines then insert clips on either end
33-36 psi
how do i drop the fuel tank on a FORD EXCURSION 5.4L
how do you change a fuel filter and were is it located on a 2000 xlt ford ranger
the relay is behind the radio in a dual relay block
The fuel pump inertia switch is in the right front passenger footwell , by the kick panel
On a 2000 Ford Windstar : There are ( 3 or 4 filters ) It may be equipped with a cabin air filter For the engine there is the air filter , oil filter , fuel filter
The fuel pump relay for a 2000 Ford Excursion is typically located in the power distribution box under the hood. This box is positioned near the battery on the driver's side. To identify the relay, you can refer to the diagram on the cover of the power distribution box, which will indicate the specific position of the fuel pump relay.
The main fuel filter is on the frame rail almost directly under the driver's seat.
look under the dash on the passenger side, its on the right kick panel.