answersLogoWhite

0

The windshield washer pump 10A fuse is in a fuse box located under the hood near the battery.

Chevrolet has come out with a service bulletin indicating that the 10A fuse is inadequate for circuit operation.

Chevrolet is suggesting to increase fuse size to 15A.

Rich B.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What fuse runs washer fluid motor for 2006 impala?

There seems to be none. Neither the Owner's Manual or the Haynes Repair Manual show a fuse for the Windshield Washer Pump...


Where is the fuse in your Lincoln ls for the washer fluid?

In the Lincoln LS, the fuse for the washer fluid pump is typically located in the fuse box under the hood. Specifically, you should check the fuse labeled for the windshield washer or washer fluid, which is usually indicated in the fuse box cover diagram. If the fuse is blown, replacing it should restore functionality to the washer fluid system. Always consult your owner’s manual for the exact location and specifications.


How do you disconnect your washer fluid fuse?

Identify the fuse. Remove it


Which fuse controls the windshield washer fluid pump for an 2003 Dodge Ram?

The windshield washer fluid pump has a fuse in the fuse box. The location of the fuse is listed on the inside cover of the fuse box.


Does a 2006 Chevy Impala Lt have a fuse for the windshield washer?

A 2006 Chevy Impala Lt has a fuse for the windshield washer located in the main engine compartment. It is contained within a water tight box at the right, rear of the compartment.


How do you replace windshield washer fuse 2006 impala?

To replace the windshield washer fuse in a 2006 Chevy Impala, first locate the fuse panel, which is typically found under the dashboard on the driver's side. Open the fuse panel cover and identify the fuse for the windshield washer, usually labeled as "WASHER" in the diagram on the cover. Use a fuse puller or a pair of pliers to remove the blown fuse and replace it with a new fuse of the same amperage. Finally, close the fuse panel and test the windshield washer to ensure it’s working properly.


Where is the fuse for a 2010 Ford Escape washer fluid pump?

The fuse for the washer fluid pump in a 2010 Ford Escape is located in the fuse box under the dashboard on the driver's side. Specifically, you will want to check the fuse labeled "Wiper" or "Washer" in the fuse panel. If the fuse is blown, replacing it should restore function to the washer fluid pump. Always consult the owner’s manual for exact fuse locations and specifications.


1998 grand prix fuse for washer fluid motor?

2003 grand pirx washer fluid motor


What can cause the fluid pump For windshield washer to not work on a 2008 Chevy impala The wind shield wiper pump not working on a 2008 Chevy impala when full could be merely the fuse blown?

Several factors can cause the windshield washer pump on a 2008 Chevy Impala to not work, even if the reservoir is full. A blown fuse is a common issue, but other possibilities include a faulty pump motor, clogged washer fluid lines, or a malfunctioning switch. Additionally, wiring issues or poor connections can prevent the pump from receiving power. It's essential to check these components systematically to identify the root cause.


What is the fuse location for the washer fluid motors?

For most cars and trucks, the fuse for the washer fluid pump motor is located in the passenger compartment fuse panel. It is either located in the glove compartment or in near the steering column.


Where is the fuse for the washer fluid motor located on a 1995 Pontiac Grand Prix?

In the fuse box


Where is the fuse for the washer fluid motor in a 1997 ford explorer?

In the fuse panel on the drivers end of the dash ( fuse panel cover is visible with the drivers door open ) fuse # 12 is a 10 amp fuse for Front Washer , Rear Washer & Wiper