The heater control valve on a 1995 Ford Explorer is typically located on the engine compartment's firewall, near the passenger side. It's connected to the heater hoses, which run from the engine to the heater core. You may need to remove some components or inspect closely to access it, as it can be somewhat hidden by other parts. Always ensure the engine is cool before attempting to locate or service the valve.
Remove the heater control valve and replace it.
why is heater on 1995 explorer lukewarm
i think you might be talking about the heater hoses , if so it might be the heater control valve . the is a upper and lower radiator hose , but nothing should be between them.
Yes you will have a heater control valve but try and locate one from other than the dealer because it will cost you around $135.00 dollars.........
The heater control valve on a 1995 GMC 1500 is typically located in the engine compartment, near the firewall on the passenger side of the vehicle. It is positioned in the heater hose line that runs from the engine to the heater core. To access it, you may need to remove some components or hoses obstructing your view. Always ensure the engine is cool before attempting to locate or service the valve.
To replace the heater control valve on a 1995 GMC Vandura, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then locate the heater control valve, typically found near the firewall. Disconnect the hoses and electrical connections, remove the mounting bolts, and take out the old valve. Install the new valve by reversing the removal process, secure everything, refill the coolant, and reconnect the battery.
The heater control valve on a 1995 Lincoln Town Car is located in the engine compartment, typically near the firewall on the passenger side. It is connected to the heater hoses that run to the heater core. To access it, you may need to remove some components for better visibility and reach. Always ensure the engine is cool before attempting any repairs.
The heater control valve on a 1995 Jeep Cherokee Laredo is typically located near the firewall, on the passenger side of the engine compartment. It is connected to the heater hoses that run into the cabin for heating. To access it, you may need to remove some components or hoses for better visibility. Always ensure the engine is cool before attempting to locate or work on the valve.
Starting with the 1995 model of Ford Explorer the automatic transmission was ELECTRONICALLY controlled , so there is no modulator valve
There isn't a water control valve on a Dodge Ram. The heater core gets full flow all the time, the amount of air inside the HVAC housing that goes through the heater core is what regulates output temp. That airflow is controlled by a blend air door.
its next to the blower motor
It should be the same as my 1995 - at the firewall the heater hose nearest the drivers side is the inlet hose to the heater core