to be certain, I'd get a manual... or borrow one from the library d
its located on the heater core
2 - inlet & outlet
The heater inlet hose on a 92 Geo Metro is located in the rear of the engine compartment. It runs through the firewall and connects to the heater.
Simple, take the inlet and outlet hoses going to and from the heater core and connect them together.
On the firewall, under the hood, you will find the inlet and outlet hoses.
The heater inlet hose on a 1999 Jeep Wrangler 4.0L is located in the left, rear of the engine compartment. It connects directly to the heater core which circulates heat throughout the cabin.
its underneathe the alternater, right next to the bypass hose inlet.
Located at the evaporator inlet which is under the dash in the heater/AC housing.
There are two hoses that connect to the heater core, and they are located next to the brake master cylinder, on the driver side of the van. I believe the bottom hose is the inlet and the top hose is the outlet. Good Luck, Greg
It is located directly under the throttel body.AnswerWhere is the thermostat on a 2002 Pontiac Grand Am?" Answerwhere is the thermostat on a 2000 Pontiac grand am Instructions on how to change a thermo..Hello, this page has instructions on how to install a new thermostat on a 99+ Grand Am. Also, not listed on the page as an instruction but something I did when changing the thermostat was to take off the throttle body which made getting to the inlet manifold bolts much easier. The bottom bolt was particulary hard to get too, the top bolt was not too bad. Good Luck. http://www.grandamgt.com/thermostat-pfyc.HTML
The heater core is located behind the dash inside the heater core box with two ports, an inlet and an outlet port protruding through the firewall into the engine compartment.
The outlet from the engine that feeds hot coolant into the heater core is usually (but not always) located close to the thermostat. The return hose from the heater core usually returns into the water pump.