On the back end of the throttle body (left looking from front). its held in by 1 Phillips (can use screw driver) or a 8mm socket to remove. DO NOT CLEAN WITH INTAKE CLEANER USE ELECTRONIC CLEANER if you decide to clean before replacing. Vehicles get dust build up on the small black box located on the right corner end of manifold. There will be a plastic rod connecting the box to manifold. Spray small amount of wd40 on the box where rod is and move rod slowly back and forth. You should notice the difference and smoothness. That rod opens and closes the air feed to the cylinders if its stuck. You WILL have idle issues and possible a no start if stuck closed. If still having issue refer to your dealer with TSB#18-004-06. To findout if your computer has received the update regarding the idle control valve.
If you are looking for a valve in the heater hoses that restricts coolant flow, it does not have one.
The egr valve on a Chrysler Pacifica is on the front of the engine. It is near the top, behind the water pump.
It is on the valve body, inside the transmission.
The EGR valve on a 2.5L 2005 pacifica is located behind the engine on the right hand side. shouold be same on '04It is on the driver side rear of the engine.
On top of the rear (back side) valve cover. Note: these screw in and have an o-ring seal.
It does not have a heater control valve.It does not have a heater control valve.
A 2000 Chrysler 300m does not have a heater valve. The cabin temperature is controlled by airflow doors.
A 2001 Chrysler Town and Country does not have a water control valve in the heater system. The cabin temperature is controlled with electric motors on airflow control doors.
right rear of engine connected to exhaust manifold.
The valve needs replaced. There is a metal plug that has fallen out.
You have to call your local dealer with the VIN to answer that question.
It is inside the transmission, on the valve body. It is called a TRS (trans range sensor).