0
On a 1992 Geo Metro, the ignition control module is typically located on the driver's side of the engine compartment, mounted on or near the ignition coil. It can be found on the firewall or near the engine's intake manifold, depending on the specific engine configuration. For easier access, it may be necessary to remove some components surrounding the area. Always refer to the vehicle's service manual for the most accurate location and removal instructions.
What else can I help you with?
Where is the ignition control module on 1996 Geo Metro?
The ignition control module on a 1996 Geo Metro is typically located near the engine, mounted on or near the ignition coil. It's often found on the driver's side of the engine compartment, close to the firewall. For easier access, you may need to remove some components or covers. Always consult the vehicle's service manual for specific instructions related to your model.
Where is the ignition control module on a 1997 Geo Metro?
In a 1997 Geo Metro, the ignition control module is typically located on the engine, mounted near the ignition coil, often on the passenger side of the engine compartment. It may be attached to the engine block or the firewall, depending on the specific engine configuration. To access it, you might need to remove any obstructions, such as the air intake or other components. Always consult the vehicle's service manual for precise location and removal instructions.
Where is the transmission control module 1995 Geo Metro?
it is in the transmission
Where is the transmission control module on a 1993 Geo Metro?
THE TCM is located on the left side of the steering column , It is a gray metal box roughly 4"x 4" with 2 white connectors
On 91 Geo Metro Convertible .Why do you have to run a hot wire to the coil to get it to run.I have replaced the ECU and that did not work?
Does it have an ignition control module? That may be the cause. Or possibly a MAP sensor or a Crank position sensor or Cam position sensor. Check those first.
Where is the computer located in a 1998 Chevy metro?
In a 1998 Chevy Metro, the computer, also known as the Engine Control Module (ECM), is typically located under the dashboard on the driver's side. It is usually mounted above the brake pedal area or near the steering column. Accessing it may require removing some panels for better visibility.
Where is the ECM located on a 1992 Geo Metro?
The Engine Control Module (ECM) on a 1992 Geo Metro is typically located under the dashboard on the driver's side, near the steering column. It may be secured to the vehicle's firewall or mounted on a bracket. To access it, you might need to remove some trim pieces or the cover under the steering wheel. Always consult the vehicle’s service manual for specific instructions and safety precautions.
Where can you buy an ignition switch for a 1997 Geo Metro?
www.advanceautoparts.com
How do you test a Geo Metro 1995 ignition coil?
A 1995 Geo Metro ignition coil is tested by measuring the resistance across the coil. If it exceeds the manufacturer's recommendation, it must be replaced.
Where is Metro State College located?
Metro State College is located in the state of Colorado.
How do you reset the engine control module in your 1996 Geo Metro?
To reset the engine control module (ECM) in a 1996 Geo Metro, you can disconnect the negative terminal of the battery and leave it off for about 15-30 minutes. This will allow the ECM to reset and clear any stored trouble codes. Afterward, reconnect the battery terminal and start the vehicle, allowing the ECM to re-learn the engine parameters. If issues persist, it may be necessary to check for underlying problems or consult a mechanic.
Where is the Geo Metro 1997 coil ignition placed?
Firewall Drivers Side
