0
The ignition control module on a 1996 Geo Metro is typically located near the engine, mounted on or near the ignition coil. It's often found on the driver's side of the engine compartment, close to the firewall. For easier access, you may need to remove some components or covers. Always consult the vehicle's service manual for specific instructions related to your model.
What else can I help you with?
How do you change the ignition control module on 1996 mercury cougar xr7?
there is no ignition control module on the 1996 model its all through the PCM
Where is the ignition control module located on a 1996 dodge neon?
Autozone
Where is the ignition control module on an 1996 mercury mystique located?
na/
Where is the ignition control module on a 1997 Sonata?
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
Where is the ignition module on a 1996 stratus?
The engine computer is the ignition module.
Is there a distributor - ignition control module on 1996 or newer Taurus - Sables?
AnswerSince 1996, engine ignition control has been handled by the Powertrain Control Module (PCM).The PCM has direct control over the ignition coils / coilpack (or coil-on-plug on some engines) - so the need for a 'distributor' has gone away.Coilpacks cost about $75Sidebar: without a distributor, the engine timing is also totally handled by the PCM.See "Related Questions" below for information about Ignition Control Modules on 1986-1995 Taurus/Sables.On a 1996 Ford Taurus the ignition control module is part of the drivetrain control module. To change the ignition control module you have to change out the computer. It is located behind the motor on the passenger side of the engine compartment. Look for a screw holding in a wiring plug with a dozen or so wires. The drivetrain control module has a couple of nuts holding it in place and looks like a cdrom when removed. Good luck. John
Where is the ignition control module on a 1996 3.8L Thunderbird with the distributorless ignition system?
the little gray box on top the a.c. compressor or by the radiator.
Where is the ignition control module 1996 miata?
In a 1996 Mazda Miata, the ignition control module is integrated into the distributor assembly. To access it, you'll need to locate the distributor, which is mounted on the engine near the front, and then remove it to reach the module. It's important to handle the components carefully to avoid damaging any parts during the process.
Where is and how to you relace ignition control module 1996 Buick Riviera?
In the distributor, buy a new one and read the instructions
Where is the ignition control module for the 1996 probe 2.0?
it should be located under the battery on the inside of the front fender.
Ignition module location 1996 ford thunderbird 4.6?
The Ignition Control Module on a 1996 Ford Thunderbird 4.6 is located inside the EFI or Electronic Fuel Injector. The EFI is the carburetor. Look for a cord that has a connector that resembles an HD Cable.
Where is the ignition control module on a 1996 Chevy Impala SS?
its located on driver side head on top of block little black module with plugwire running out of it
