its located on driver side head on top of block little black module with plugwire running out of it
where is the ignition control module loacted on a 1997 chevy cavalier
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
Where is the control module located on the 1983 Chevy blazer
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
The ignition module is located in the distributor, under the distributor cap.
Which engine does your car have?
Its under the dash near the drivers left knee area
All 1987 to 1990 Chevy Celebrity engines use distributorless ignition. Timing is controlled by the engine control module in conjunction with the ignition module. There is no provision for adjustment.
under the coil pack or on the distrbutor
under the distributer cap
On a 2004 Chevy Impala, the traction control sensor is located in the ABS pump module. On the driver side of the car, the sensor is located at the left center of the engine compartment with black wires hanging from it.