answersLogoWhite

0

Under hood, driver side, front side of strut tower, mounted on fenderwell For a 5.0L engine

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

In a 1984 Toyota Supra where is the control module or ignition module?

The Ignition control module is located under the coil which is on top of the driver side wheel well, Commonly known as an ignitor.


Where is the ignition control module on a 1984 Ford Escort 1.6 liter?

The ignition module is mounted to the side of the distributor. It a rectangular piece.


Where is the ignition module 1984 Corvette?

The ignition module is located in the distributor under the rotor, it plugs in.


Where is the ignition module located 1984 corvette?

The ignition module is located in the distributor under the rotor, it plugs in.


Why wont your 1984 dodge startengine turns overhas fuel at carb does not have ignition spark?

== answer== Could be a bad ignition control module or coil,points if equiped,cap,or rotor,bad ignition switch.


How do you install an ignition module on a 1984 Nissan Pulsar NX?

its inside the distributor


Where is the control module or ignition module located in a 1984 Corolla?

Attached to the ignition coil you will find an "igniter". Per the local Toyota Dealer parts dept. there is no ignition module. The igniter takes it's place. I have been trying to locate the module on my 1980 corona as well and that was the answer they gave me. Try this eBay link and you will see a picture of the igniter: http://cgi.eBay.com/83-88-TOYOTA-COROLLA-TERCEL-NOVA-IGNITER-89620-16080_W0QQitemZ130140198470QQihZ003QQcategoryZ33691QQrdZ1QQssPageNameZWD1VQQcmdZViewItem?_trksid=p1638.m118


Where is the crankshaft sensor on a 1984 Chevy Celebrity 2.8L?

It does not have one. Crankshaft position sensors are used in distributorless ignition systems to tell the ignition control module where the crankshaft is in its rotation. The 1982 thru 1986 2.8L engines had distributors so they had no need of a crankshaft position sensor.


How do i test the ignition module in my 1984 Ford Laser?

There is no ignition module in a '84 laser. They have a coil and distributor unless it has been modified. If you don't get a spark across the points in the distributor when you try to start the engine you probably need a new coil.


Ignition module on a 1984 Mercury Topaz?

Really going back in time. If it is the same as the '87, the module is on the firewall. Small box with a wire plug in. Sort of silver in color. Most times when this module is defective, the engine will cut out, and after a few minutes will restart. Ford should still have the part in stock. Just make sure the points are gapped properly and the rotor is in good shape.


Where is the electronic spark control module on a 1984 gmc pickup?

Inside the distributor, under the rotor.


How do you change the air fuel ratio on a 1984 Chevrolet Camaro?

It is set and adjusted by the engine control module.