answersLogoWhite

0

If your key is stuck: on the underside of the steering column cover there is a round recess cover. Remove the cover and using a pecil push up through the recess.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you install ignition lock cylinder on a 2000 Pontiac grand am?

I got a friend whose key can't turn the ignition on her 2000 Pontiac Grand Am. She can't get the steering wheel to unlock either.


What would cause an ignition to lock on a Pontiac grand am?

the steering wheel..


How do you replace the ignition in a 2001 Pontiac Grand Am?

ignition what? coil, swicth,module, lock cylinder? gm Jim


How do you install the ignition switch in a 2004 Pontiac grand am?

The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.


How do you remove the ignition lock cylinder on a 1994 Grand Am?

The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.


How much does a ignition lock for a 2001 Pontiac grand am cost?

I'd check the AutoZone or O'riely's websites to compare prices.


Why would the ignition switch in a 1995 Pontiac Grand Prix sometimes lock up in the run or unlock position?

Your ignition lock mechanism is worn/damaged (How much junk do you have on that key ring, Bub?). It needs to be replaced.


Need removal and installation instructions for an ignition cylinder 2000 Grand Cherokee Jeep?

Need removal and installation instructions for an ignition lock cylinder -- 1999 Grand Cherokee Limited?


Where is the ignition switch on a 2004 Pontiac Grand Am?

The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.


Where is the ignition module for a Pontiac Grand Am gt at?

Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products. Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products.


Where is ignition switch located on 2000 Pontiac Montana?

On the 2000 Pontiac Montana, the ignition switch is located on the steering column, behind the steering wheel. To access it, you typically need to remove the lower steering column cover. This switch is connected to the ignition lock cylinder, allowing you to start the vehicle when the key is turned.


How to fix a 1996 Pontiac grandam ignition locked?

Replace the ignition lock cylinder.