0
What else can I help you with?
What does a knock sensor for a 1991 Chevrolet Camaro 305 look like?
the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.
Location of knock sensor 1991 GMC sierra?
Location of knock sensor 1991 GM sierra 350 2500?
Where is the knock sensor on a 4x4 1991 Ford Explorer?
There is no "knock sensor" on a 4.0L engine
Does a 1991 camaro rs have a gas sensor and if it goes bad where are they located?
Gas sensor? Not sure what you mean, could it be a Fuel gauge sensor? Oxygen sensor? Fuel pressure regulator?
Where is fan sensor located on a 1991 Camaro with a V6 engine?
It screws into the intake manifold next to thee thermostat housing.
Where is the knock sensor on a 1991 Olds Cutless Supreme?
The knock sensor is located on the left side of the block. Often the steering shaft will contact and wrap the wiring harness around it, braking the connector. You should check this first, before replacing the sensor.
What is the function of a knock sensor on a 1991 4.3 s10?
The function of the knock sensor ob a sensor on a 1991 4.3 s10 is to provide the computer the position of the crank shaft to give it the right information to get correct timing. That would be the crank position sensor. The knock sensor monitors the engine for spark knock (ping) so the ECM (Engine Control Module) can retard the timing to eliminate it.
Where is the knock sensor on a 1991 300zx 2 2 non turbo?
The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.
Where is the knock sensor on a 1991 Chevy k1500?
It is located right above the starter for a 5.7l V8, not sure for the 4.3 or 5.0, probably the same place
Where is the knock sensor located in a 1991 Pontiac 6000 le?
In a 1991 Pontiac 6000 LE, the knock sensor is typically located on the engine block, often near the intake manifold or cylinder head. It may be positioned on the driver's side of the engine, mounted to the block. For precise identification, it's best to consult the vehicle’s service manual or a repair guide specific to that model.
Where is the knock sensor on a 1994 Jeep Cherokee Sport 4.0?
There is no knock sensor on a 94 4L jeep engine. In 1991 when they changed to the 4L HO motor, they removed the knock sensor from the system.
Where is iat sensor located on a 1991 camaro?
The iat sensor is in the air filter element. First you take the air filter cover off then you take your air filter out and pick up the housing you will see the only connector with a pigtail. That is your iat sensor!
