There are 2 of them, And they are underneith the intake manifold.
You will have to remove the intake manifold to get to them.
On engine block
Where is the knock sensor located on impala SS
The 2006 Dodge charger knock sensor is located on the back of the engine. The knock sensor will be near the bottom of the engine cover.
Right above the starter .
On a 2006 Toyota Sequoia, the knock sensor is located on the engine block, specifically on the driver's side, near the rear of the engine. It is typically found beneath the intake manifold, making it somewhat difficult to access. To reach it, you may need to remove the intake manifold and other components.
That engine has 2 knock sensers on it and there both underneith the intake manifold. You can't see are even get to them until you remove the intake.
The knock sensor in a 2006 Cadillac STS is located on the engine block, specifically on the driver’s side, beneath the intake manifold. It is typically positioned near the cylinder bank to detect engine vibrations and adjust timing accordingly. Accessing it usually requires removing the intake manifold for proper visibility and service.
In the trunk.
Need to KNOW the engine size.
To change the knock sensor on a 2006 Nissan Murano, first, disconnect the negative battery terminal to ensure safety. Next, remove the intake manifold to access the sensor, which is located on the engine block. Unplug the electrical connector from the old sensor, unscrew it, and then replace it with the new sensor, reconnecting the electrical connector. Finally, reassemble the intake manifold and reconnect the battery terminal to complete the installation.
the knock sensor is most likely underneath the intake manifold. i know that is where it is on a 2002 4.6 .
The Duramax don't have a knock sensor.