0
On a 2006 Toyota Sequoia, the knock sensor is located on the engine block, specifically on the driver's side, near the rear of the engine. It is typically found beneath the intake manifold, making it somewhat difficult to access. To reach it, you may need to remove the intake manifold and other components.
What else can I help you with?
Where is the knock sensor located on a Toyota 22re?
engine bay
Where is the knock sensor located 1998 Toyota Camry?
Knock sensor is located in the wall of the engine block facing the firewall. You have lift the car if you want to reach it.
Where is the knock sensor located on a 1996 Toyota Avalon?
under the intake manifold
Toyota Celica knock sensor location?
The manufacturer states throttle body and the intake manifold must be removed to access the knock sensor. The knock sensor is located on side of cylinder block.
Were is the knock sensor on a 2.2L 4cylinder Toyota?
The Knock sesor is located on the backside of the block right underneath intake manifold.
Where is 1992 Toyota Camry knock sensor located?
It should be in the side of the engine facing the firewall.
Where is the knock sensor located on a 1990 Toyota pickup 30L 3VZE?
it's located under the intake manifold. the knock sensor is most likely ok' the porblem is the short wiring harness from sensor to main wire harness.
Where is knock sensor on 95 5.0?
where is the knock sensor on a 95 Toyota t100 v6
Where is the 1993 Toyota knock sensor on a 3.0 located?
in the catylitic converter (underneath car...connected to your exhaust
Show where the knock sensor located?
can you tell me where the knock sensor is located on a 3.3l mercury villager
Where is the knock sensor located on a Toyota 3.0 liter?
you have to remove the intake and it is located inside the engine block,you can see it once you remove the intake........
How do you replace the knock sensor on a 1989 Toyota supra turbo?
the knock sensor is located on the driver side of the engine right under the intake it is about 1 in. it is connected so you will have to unplug it and then just screw it off
