0
First off, what size engine is in this vehicle? Usually they have 3.3L and the knock sensor is located at the rear of the block on the right hand side. It is round with a signal wire going to it. This would be looking up from the bottom of the car (on the hoist). macthemechanicca2001@Yahoo.ca
What else can I help you with?
How do you remove a knock sensor in an Oldsmobile cutlass ciera?
where is the knock sensor located on 93 cutlass ciera
Where is the knock sensor located on a 1996 Oldsmobile aurora?
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
How do you change knock sensor 3.1 95 lumina?
were is knock sensor on 3.1 cutlass supreme
How do you repair the timing on a 1991 Oldsmobile Cutlass Supreme 3.1 liter V6?
You can't, its done by the computer if you have a knock noise, replace the knock sensor. its locate on the back of the engine near the alternator.
Where is the knock sensor located on a 95 oldsmobile 98 with a 3800 engine?
The knock sensor is located on the 95 oldsmobile 98 with a 3800 engine under the midpoint of the heads.
Where is the knock sensor on a 1990 Oldsmobile cutlass with 3.1 motor?
On a 1990 Oldsmobile Cutlass with a 3.1-liter engine, the knock sensor is typically located on the engine block, near the intake manifold. Specifically, it can be found on the driver's side, beneath the intake manifold, towards the rear of the engine. Accessing it may require removing some components for better visibility and reach. Always consult the vehicle's service manual for precise instructions and location details.
Where can you find the Knock sensor on a 1991 Oldsmobile cutlass calais?
If it is a quad 4, the knock sensor is on the firewall side of the engine, at the transmission end of the engine, just below the exhaust manifold. It has a single lead and is about 2" in diameter and 1-1/2" high. Use a proper fitting socket or wrench to unscrew it.
Knock sensor location for 99 alero?
On a 1999 Oldsmobile Alero, the knock sensor is located on the engine block. It may be bolted to the intake manifold, or to either side of the block.
Does a 94 integra have a knock sensor?
LS does not have a knock sensor. GSR does have a knock sensor
What sensors are needed to be changed out from 95 ciera model three one L v6 engine to match back the original 95 supreme three one L v6 engine so the original engine harness fits the ciera engine?
Sensors needed to be changed out from 95 ciera model three one L V6 engine to match back the original 95 supereme three L6 engine are Ciera Knock Sensor and Soeedometer Sensor.
What problems do the knock sensor indicate?
The knock sensor detects spark knock or ping.
Where is the knock 1 sensor located in a 1997 Oldsmobile Aurora?
The knock sensor in a 1997 Oldsmobile Aurora is located on the engine block, specifically on the lower part of the engine near the cylinder heads. It is typically positioned on the driver's side, between the intake manifold and the engine block. To access it, you may need to remove some components, as it can be somewhat difficult to reach.
