The lambda sensor, also known as the oxygen sensor, on a Ford Mondeo is typically located in the exhaust system. There are usually two sensors: one positioned before the catalytic converter (upstream) and another after it (downstream). To find the exact location, it’s best to refer to the vehicle's service manual, as the placement may vary slightly depending on the engine type and model year.
On a 2-liter Mk III Mondeo TDCi, the lambda sensor, also known as the oxygen sensor, is typically located in the exhaust system. There are usually two sensors: one positioned before the catalytic converter (upstream) and another after it (downstream). To access the upstream sensor, you may need to raise the vehicle for better visibility and reach. Always consult the vehicle's repair manual for specific details and guidance.
inlet manifold about halfway down
The intake air temperature or IAT sensor on the 2006 Mondeo is located inside the mass airflow sensor or MAF. In older models it was in the tubing, but now the IAT and MAF are combined.
Lambda is o2 sensor in exhaust pipe.
The lambda sensor reads the oxygen in the exhaust stream.
Ford Mondeo was created in 1993.
Year, engine?? Normaly lambda sensor is below exhaust collector
174 Lambda sensor (right) slow response 76k - 11 sec @ 56kLambda sensors / exhaust oxygen sensorsThe exhaust gas oxygen sensor (EGO or O2), or lambda sensor, is the key sensor in the engine fuel control feedback loop. ... The lambda sensor's output voltage doesn't remain constant, however.www.picotech.com/auto/lambda_sensor.html www.picotech.com/auto/lambda_sensor.html · Cached . Hope this helps.
The Lambda Sensor is situated in exhaust downpipe with connector rear of engine N/S.
where is the right hand bank lambda sensor on a V12 1992 XJS
oxygen sensor
Ford Mondeo sales were high in 2002. Ford Mondeo was the fifth highest selling car in the entire UK in 2002.