Located on top of the A/C dryer located on the passenger side fire wall
The switch is under the dash connected to the push rod for the clutch master cylinder.
35 or 39 PSI
May be on the upper end of the clutch pedal under dash area
The oil pressure switch on a 1989 Chevy Camaro RS is located on the bottom of the engine hear the oil filter. It constantly monitors oil pressure and updates the computer on its status.
all depends if you do it your self or not if you do it the kit will run you about $250.00 that is the release bearing, clutch and pressure plate
There is a CEL, Check Engine Light, on the 1989 Thunderbird.
Yes, this switch must be activated to allow the engine to start. If this switch has failed, it may function improperly or not at all.
Flywheel must be torqued to 105 ft/lbs. Clutch and pressure plate torqued to 22 ft/lbs.
It's located under the dash wher the clutch peddle is attached to the hinge. It's fight next to the break sensor.
It requires a special socket to fit it.
To prime the clutch on a 1989 Audi, first ensure that the hydraulic system is properly bled to remove any air. Locate the clutch master cylinder, then fill it with the appropriate hydraulic fluid. Pump the clutch pedal several times to build pressure, and check for any leaks. Finally, ensure that the clutch engages and disengages smoothly before driving.
the oil pressure switch is located in the rear of the engine compartment on the drivers side under the valve cover