The map sensor on a 1994 Geo Metro is typically located on the engine intake manifold, near the throttle body. It is a small electronic component connected by a couple of vacuum hoses and an electrical connector. To access it, you may need to remove some engine covers or components for better visibility. Always refer to the vehicle’s service manual for specific details and diagrams.
The MAP (Manifold Absolute Pressure) sensor on a 1997 Geo Metro is typically located on the intake manifold, near the throttle body. It is a small, rectangular component with an electrical connector and a vacuum line attached to it. To access it, you may need to remove some engine covers or components for better visibility. Always ensure the engine is off and cool before attempting to locate or service the MAP sensor.
Does it have an ignition control module? That may be the cause. Or possibly a MAP sensor or a Crank position sensor or Cam position sensor. Check those first.
MAP Sensor on a 1994 Cougar is located on the firewall. Has a vacuum hose coming from it and an electrical connection.
The 1994 Ford Ranger pickup truck map sensor is located behind the dashboard, on the passenger side of the passenger compartment. The map sensor is contained in a dust free box.
The map sensor is located on the intake manifold of a 1994 Ford. It could also be located on the plenum by the throttle body.
where is a map sensor loction for 1994 ponatic bonneville?
ok, I have the haynes geo repair manual it says code 23 , manifold air temperature (mat) /intake air temperature (iat) sensor circuit code 31 & 32, manifold absolute pressure (map) sensor circuit the above sensors eather need to be replaced or checked for problems with the sensor.
No, It has to have it.
Try the right (passenger) side firewall near battery.
The 1994 S10 uses a MAP sensor, not a MAF sensor. We need to know size engine you have in that S10.
Had the same problem with my 96 Geo Metro........ I replaced the catalytic converter....... Real easy car to work on. Part was about $100 from www.rockauto.com heat up the bolts with some map gas and the bolts will come off
The 850 does not use a MAP sensor. It uses a MAF sensor that is located and attached to the air filter housing lid