answersLogoWhite

0

If you have the 4.2, it is on the passenger side of the engine near where the dipstick enters the block, forward of the starter.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the oil pressure sending unit located on a 1989 Ford Ranger?

located below the oil filter


Where is the oil pressure sending switch on a 1989 GMC Sierra not the fuel pump relay?

The oil pressure sending unit on a 1989 GMC Sierra is located slightly above the oil filter. You will need a flashlight to find it. It may be hard to recognize it because it should have a heat shield around it as well. Look for its wire coming down from the engine compartment and follow it to the oil pressure sending unit. Drain your engine oil and remove the oil filter to make changing the oil pressure sending unit easier.


Does the pressure plate on 1989 jeep wrangler yj go on only one way?

Yes


Where is the fuse box for a 1989 jeep wrangler located?

drivers side kick panel


Where is the oil pressure gage on the 1989 Pontiac Bonneville?

the guage should be located in your dash next to the speedometer, but if you are reffering to the pressure sending unit it is located on passenger side, behind the powersteering pull best accessed for wheel well or from below the car


Where is the windshield wiper motor located on a 1987 jeep wrangler?

Where is the wiper motor located on a 1989 jeep wrang ler


Where is the oil pressure sender on 1989 astrovan?

You need to remove the dog house (rear engine cover). The oil pressure sending unit is located next to the distribiture. It usually has a plug with just one wire.


Where is the Temperature gauge sending unit on a 1989 Honda accord lxi?

The temperature gauge sending unit, located on a 1989 Honda Accord LXI is located on the thermostat. It is the small connection with a single wire sticking out of it.


Where is the oil pressure sending switch located on a 1989 Toyota Tercel?

i would check the oil pan if its not there check the front of the block just above the oil pan if its not there then it will be near the oil filter


Where is the pressure gauge sensor on the 1989 Ford Ranger 4 cylinder 2.3 engine?

The oil pressure sending unit is located on the drivers side of the engine on the rear of the head. It has one wire going to it. It's a pain in the butt to get to. I'm looking for the temp sending unit on my 89 4cy ranger. Any idea?


Where is the EGR valve located on a 1989 Jeep Wrangler 4.2?

Looking at the front of the motor, the egr valve is located on the right lower side of the carburetor.


Will a 1989 Jeep Wrangler hardtop fit on a 1999 Jeep Wrangler?

No.