answersLogoWhite

0

Just finished changing one tonight, it's on the top rear of the block behind the intake manifold. beside the distributor. Purchased the replacement unit at the parts store so I would know what to look for. There is a wire harness connector on one side and a manifold bolt on the other so it is tight to get into, had to use a 12 point thin-wall deep 1-1/16" socket to get it out (a deep 6 point impact socket won't clear). Then slid a 6" long piece of rubber hose over the replacement unit to get it started back in the hole (couldn't get access to install by hand). Be sure and blow off the dirt and debris, with an air hose, before you remove the old unit.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What type of tool do you use to take off a 97 dodge stratus oil sending unit?

An oil pressure sensor socket.An oil pressure sensor socket.


Oil pressure gauge not working?

replace oil sensor unit


Is an oil sensor and an oil pressure sending unit the same thing?

It could be. An oil sensor could measure pressure, temperature, level, or quality.


What is the Plug or sensor above oil filter on 96 Cherokee?

The plug or sensor above the oil filter on a 1996 Cherokee is the oil pressure sending unit. This sensor controls the oil pressure gauge.


Where is oil sending unit on 2006 dodge sprinter?

The Sprinter does not have an oil pressure sensor. The oil level sensor mounts to the side of the oil pan.


Where is the oil pressure sending unit on a 95 Saturn sl1?

On the 1995 Saturn SL1 The oil pressure sending unit is the sensor closest to the alternator. The unit is on the back of the block.


Where is oil pressure sending unit on 2002 Saturn sl1?

The oil pressure sending unit is located on the back of the block. it is the sensor located closest to the alternator.


Does the Mercedes C220 elegance have a oil pressure sensor unit on the engine?

Yes.


How do you install a oil pressure sending unit?

Locate the engine's oil pressure sensor, remove it and add T-branch between. Then attach the oil-gauge's/unit's oil-line to the T-branch.


Where is the oil pressure sensor located on a 1995 cavalier 2.2?

the oil pressure sending unit for a 1995 Cavalier 2.2 is on the side of the engine. The sensor is located just behind the oil filter.


Is the oil pump bad when you have low oil pressure?

it could be or it might just be the oil sending unit (sensor)


Oil pressure sending unit on 1991 ford ranger 2.3?

the oil pressure sending unit is designed to warn you of a low oil pressure. If the sensor goes bad then the low pressure light or gauge will read low when the oil pressure is actually ok.