On a 1993 Ford Ranger, the orifice tube is located in the air conditioning system, specifically in the liquid line. To access it, you typically need to locate the line that runs from the condenser to the evaporator. The orifice tube is usually found near the evaporator, often positioned within the line itself, and may require some disassembly to reach.
the fuel pump is located inside the gas tank of my 93 ford ranger
The orifice tube on a 1993 Ford Aerostar is located in the refrigerant line, typically near the condenser or evaporator. To replace it, first, ensure the AC system is discharged and safely remove the refrigerant. Then, locate the orifice tube in the line, disconnect the line fittings, and use a small tool to extract the old tube. Insert the new orifice tube, reattach the lines, and recharge the AC system.
If its a single evaporator unit (front air only). then it is probably located in the condensor. If it is a dual unit (front and back), the front orfice tube will probably be after the "Y" in the compressor high pressure line, and prior to the accumulator. The rear unit does not use an orifice, but rather a Thermal expansion valve.
where is the horn relay on a 93 ranger
The computer on a 1993 Ford Ranger is located in the dash in the center just above the transmission hump. The computer is located just below the heater control panel.
its mounted to the frame under the drivers seat
on your starter which should be next to the oil pan on the underside of your truck
The fuse for the fog lights in a 1993 Ford Ranger is located in the fuse box. The fuse box is located under the hood, or under the driver side dash board.
What is the fireing order plug 93 ford ranger xlt 3.0
In the inlet line on the evaporator core. It is the smaller one.
you dump rite down the dipstick tube
93 thru 99 3.0 motors have IAT but later models do not