On a 1995 Chevrolet Suburban, the orifice tube is located in the air conditioning system, typically within the liquid line that runs between the condenser and the evaporator. To access it, you may need to remove the dash or some panels to reach the evaporator housing. It's usually found near the firewall, in the engine compartment, or close to the evaporator core. Make sure to discharge the AC system safely before attempting to replace the orifice tube.
I have 1998 chev suburban with rear air do they use two orifice tubes
Most orifice tubes are placed in the high pressure line to the evaporator at the fire wall connection. You will have to empty the freon from the system to replace the orifice tube which is not very expensive (the tube, that is).
To install the orifice tube in a 2003 Chevrolet Suburban, first ensure the vehicle is off and the AC system is fully discharged. Locate the orifice tube, which is typically found in the liquid line between the condenser and the evaporator. Remove the old orifice tube using pliers or a puller, clean the area, and then insert the new orifice tube, ensuring it is seated properly. Finally, reassemble any components and recharge the AC system.
Located in front of the radiator on the passenger side in the condensor line.
On some suburbans its at the connection behind passenger turn signal.
The orifice tube on a 1997 GMC Suburban is located in the high-pressure line of the air conditioning system, specifically inside the liquid line. To access it, you typically need to locate the liquid line running from the condenser to the evaporator, and the orifice tube is usually situated near the evaporator inlet. It may require some disassembly of components to reach it properly for replacement or inspection.
To install an orifice tube in a 1994 Suburban, first, locate the tube, which is typically found in the liquid line between the condenser and the evaporator. Begin by relieving the A/C system pressure and then disconnect the refrigerant lines. Remove the old orifice tube using a small pick or similar tool, and then install the new tube by sliding it into the fitting until it seats properly. Reconnect the refrigerant lines, ensuring all connections are secure, and then recharge the A/C system with the proper refrigerant.
Many GM vehicles put the AC orifice tube right after the condenser coil. It would typically be near the bottom, almost connected to the condenser. My '99 Suburban AC orifice is located in the line that runs across the passenger side inner-fender. There is a union very close to the innermost edge of the battery tray. Break that union (after relieving pressure) and you will find it there.
In a 1995 Ford Windstar, the orifice tube is located in the liquid line of the air conditioning system. Specifically, it is found between the condenser and the evaporator, typically near the firewall. To access it, you'll need to remove the A/C lines connected to the tube.
To install an orifice tube in a 1995 Buick Regal, first, ensure the A/C system is fully discharged. Locate the orifice tube, which is typically found in the A/C line between the evaporator and the condenser. Remove the retaining clip or fitting, then pull out the old tube and insert the new one, ensuring it is seated properly. Finally, reattach the fittings, recharge the A/C system, and check for leaks.
1995 nissan pickup has a expansion valve rather than a orfice tube and is located on the evap.
at the evaporator in front of the radiator where the line compression fits together